|
Continuous Tracing |
Lines and Arcs |
Place the
object on the digitizing tablet,
start Logic Trace software, choose
to trace continuously, place the pen
stylus on the edge, press down on
the tip, trace the outline, save the
DXF file
|
Choose in the
Logic Trace Software to trace using
lines and arcs, digitize three
points for the cone, in the software
switch to arcs, digitize mid point
and end point of arc, save dxf file
|
| Circles |
Smooth Curve
Fitting |
Digitize any
three points on the edge of a circle
to define a circle
|
Trace outline
using a series of points and curve
fit a Bezier smooth curve between
the points
|
| Multiple Lines
and Arcs |
Gasket Tracing |
Trace an
outline with multiple lines and arcs |
Add inside
circles for a gasket |
| |
|
| Molding |
|
Trace a marble
molding for cutting |
|
|
Combination Digitizing - Added in 2013
Update |
|
 A
new choice has
been added while
digitizing:
Combination
Digitizing. This
digitizing mode
allows users to
toggle between (1)
Freehand Tracing,
(2) Arcs, and (3)
Writing; to more
easily define
patterns or
objects which can
be defined by
using all of these
methods. This
should make
digitizing complex
designs or highly
geometric designs
with less steps
and with higher
accuracy.
|
|
Writing Mode Digitizing - Added in 2013
Update |
|
 A
new digitizing
option for any
design which has
non-continuous
lines such as
print letters.
This mode will
improve digitizing
when all or part
of a design is
disconnected.
|
|
|
|
