RhinoCAM is a Rhinoceros plug-in that runs completely inside of
Rhino 4.0/5.0. Combining the free-form modeling power of Rhino and
the legendary machining capabilities of VisualMILL, this plug-in
offers an easy to use yet powerful general purpose machining program
for the general machinist. RhinoCAM includes 2-1/2, 3, 4 & 5 axis
milling and hole making operations. It comes with hundreds of free
post-processors as well as a post-processor generator to create user
definable post-processors.
|
Place
designs and parts on the digitizing tablet, trace the design or
part, save as a dxf file for loading into Rhinocam |
An electrical device connected to a computer that sends very
accurate X,Y coordinates to the computer using a pen stylus or
mouse-like cursor. Place an object or pattern on the digitizing
tablet, start the digitizing software, place the pen stylus or
cursor where digitizing should begin, push the buttons on the pen or
cursor to start digitizing and digitize the object, pattern, design.
Digitizing tablet sizes range from 44x60in (110x150cm), 36x48in
(90x120cm), 24x36in (60x90cm), 20x24in (50x60cm), 12x18in (30x45cm),
and 12x12in (30x30cm). Standard accuracy is .01" (10/1000) but
higher accuracies are available.
Digitizing software is required to use the digitizing tablet.
More Information on Digitizing Tablets
|
 Digitizing
software that allows the user to quickly, easily, and accurately
trace parts, designs and templates and save the graphics as a DXF
file for loading into Rhinocam and other CNC software.Place the
object on the
digitizing tablet, start the Logic Trace Cnc Dxf software, trace/
digitize the design, save the DXF graphics file. Digitizing can be
point to point, continuous curves, freehand drawing, lines, arcs,
circles, and curve fitting between points.
Standard graphics formats include
DXF, DWG and GCODE file formats. Additional formats available.
More Information on the
software |
