|
Combine DXF
1. Digitize each section in the Logic Trace
CNC DXF software. When digitizing the section, you must click
the 4 points button to start the digitizing, the Combine program
uses those points for combining files.
2. When digitizing the left section,
digitize the 4 points a b c d, digitize the bject starting and
stopping on the line, then saving the file as a PLN file, file
save as LEFT.PLN.
3. When digitizing the right section,
digitize the 4 points d c e f making sure that pt d is the same
point on the template at pt d on the left section, and points c
are the same, digitize the object, save the file as right.pln.
4. Start Combine DXF, tell the program how
many section, click each section to load the DXF file, then
click the Combine button. |
