Technical Support Wintab Drivers Calcomp

The Logic Group digitizing software can be used with or without the windows wintab driver, other vender software will generally require the windows driver. The digitizer can be used connected to the computer with either the serial port or usb port (using a serial to usb adapter from radio shack).

Installation using the wintab driver

See Wintab Installation Wizard

Installation without the Wintab Driver

1. If using the serial to usb adapter, attach the usb adapter to the computer first and install the serial to usb driver that came with the adapter (the cd is in the back packaging of the adapter). After installing make sure the com port is set between com1 to com4. To check or change the com port settings, click Start, Control Panel, System (If System icon not shown, click Switch to Classic View), Hardware tab, Device Manager Button, double click Ports, double click Radio Shack USB to Serial, Port Settings tab, Advanced, change the com port.

2. If you bought a new digitizer from switch settings are the default factory settings and shown below. If you bought a used digitizer from The Logic Group, the switch settings are preset by The Logic Group and should be set at
Switch A 1,2,6,7,8,9,10,12, 14,15,16,18 on
Switch B 3,4,18 on
Switch C 3,4 on

3. Attach the pointer to the digitizer, the serial cable to the digitizer and to the computer (or the serial to usb adapter), the power supply to the digitizer and wall output, turn the digitizer on, the tablet should beep and green light come on.

4. Install The Logic Group digitizing software, start the program, click digitize new, click setup tablet setup, change driver from "wintab any manufacturer" to "Calcomp Drawingboard II/III", choose the size, choose the serial port, click install, click Default. Click text xy, digitize a point on the tablet, result should be x=xxxxx,y=yyyyy.

5. If using the serial to usb adapter occasionally windows will change the com port. If you could digitize previously but cannot now, check the serial to usb com port as mentioned in step 1.