Questions and Answers

Digitizing Drivers, Wintab, and Tabletworks

Driver instructions for Calcomp Drawingboard 2,3,4,5,6

Driver Instructions for Summagraphics Summaskech 1,2,3

Driver Instructions for GTCO Rollup 1,2,3

Driver Instructions for GTCO Super L2, L2+,L3,L4,L6

Driver Instructions for GTCO Accutab 1,2,6

Driver Instructions for Calcomp 9500

Driver Instructions for GTCO Super L and Super LX

Driver Instructions for Summagraphics Microgrid 2

Driver Instructions for Numonics Accugrid

Driver Instructions for Summagraphics Summagrid 3 and LCL

The Tabletworks wintab driver is installed but I cannot digitize?

Make sure you install the tabletworks wintab driver that came with the rollup digitizer.  After installing wintab you must open the tabletworks control panel and click the wintab button at the top of the window.

Summagrid 5 Driver Installation

For the summagrid 5 the easiest way to digitize is to install the wintab driver. I include a copy with the software or you can download it from the gtco website. After installing the driver make sure you go to the tabletworks control panel and check the wintab box. If you have the older ver 7.6 driver already installed use that version it is better than the latest ver 10.0.

How do I connect the digitizer to the usb port on my computer?

If using the serial to usb adapter, attach the usb adapter to the computer first and install the serial to usb driver that came with the adapter (the cd is in the back packaging of the adapter). After installing make sure the com port is set between com1 to com4. To check or change the com port settings, click Start, Control Panel, System (If System icon not shown, click Switch to Classic View), Hardware tab, Device Manager Button, double click Ports, double click Radio Shack USB to Serial, Port Settings tab, Advanced, change the com port.